ISO/IEC 29158:2020
2020-12
ISO/IEC 29158:2020
Résumé
This document is an engineering document intended for verifier manufacturers and application specification developers.
This document describes modifications to the symbol quality methodology defined in ISO/IEC 15415 and a symbology specification. It defines alternative illumination conditions, some new terms and parameters, modifications to the measurement and subsequent grading of certain parameters and the reporting of the grading results.
This document was developed to assess the symbol quality of direct marked parts, where the mark is applied directly to the surface of the item and the reading device is a two-dimensional imager.
When application specifications allow, this method is also potentially applicable to symbols produced by other methods. This is appropriate when direct part marked (DPM) symbols and non-DPM symbols are being scanned in the same scanning environment. The symbol grade is reported as a DPM grade rather than as an ISO/IEC 15415 grade.
Informations générales
-
État actuel: PubliéeDate de publication: 2020-12Stade: Norme internationale à réviser [90.92]
-
Edition: 1
-
Comité technique :ISO/IEC JTC 1/SC 31ICS :35.040.50
- RSS mises à jour
Prochaine édition en cours d'élaboration
ISO/IEC DIS 29158
ISO/IEC DIS 29158
Techniques automatiques d'identification et de capture de données — Ligne directrice de qualité du marquage direct sur pièce (DPM)
ISO/IEC DIS 29158
Cycle de vie
-
Précédemment
AnnuléeISO/IEC TR 29158:2011
-
Actuellement
PubliéeISO/IEC 29158:2020
Les normes ISO sont réexaminées tous les cinq ans
Stade: 90.92 (Sera révisée) -
Sera remplacée par
ProjetISO/IEC DIS 29158
