Reference number
ISO 12686:1999
International Standard
ISO 12686:1999
Metallic and other inorganic coatings — Automated controlled shot-peening of metallic articles prior to nickel, autocatalytic nickel or chromium plating, or as a final finish
Edition 1
1999-12
Preview
ISO 12686:1999
1760
недоступно на русском языке
Опубликовано (Версия 1, 1999)
Последний раз этот публикация был пересмотрен в  2022. Поэтому данная версия остается актуальной.

ISO 12686:1999

ISO 12686:1999
1760
Язык
Формат
CHF 151
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

This International Standard describes the requirements for automated, controlled shot-peening of metallic articles

prior to electrolytic or autocatalytic deposition of nickel or chromium, or as a final finish, using shot made of cast

steel, conditioned cut wire, ceramic shot or glass beads. The process is applicable to those materials on which test

work has shown it to be beneficial within given intensity ranges. It is usually not suitable for brittle materials. Handpeening

and rotary flap-peening are specifically excluded.

Shot-peening induces residual compressive stresses in the surface and near surface layers of metallic articles, and

changes the surface microstructure (including phase transformation), thereby controlling or limiting the reduction in

fatigue properties that occurs from nickel or chromium plating of the article, or increasing the fatigue properties of

unplated articles.

Общая информация

  •  : Опубликовано
     : 1999-12
    : Подтверждение действия международного стандарта [90.93]
  •  : 1
  • ISO/TC 107/SC 3
    25.220.40 
  • RSS обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ