ISO 5658-4:2001

Текущий статус : Опубликовано (Hа стадии пересмотра)

Последний раз этот стандарт был пересмотрен в 2023. Поэтому данная версия остается актуальной

	Формат	Язык
std 1 173	PDF
std 2 173	Бумажный

Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

1.1 This part of ISO 5658 specifies an intermediate-scale method of test for measuring the vertical spread

(upward and downward) of flame over a specimen of a product orientated in the vertical position. A measure of

lateral spread can also be obtained. It provides data suitable for comparing the performance of materials,

composites or assemblies, which are used as the exposed surfaces of walls or other vertically orientated products

in construction applications. Some products with profiled surfaces can also be tested with a modified procedure

representative of the end-use conditions of the product.

1.2 Upward flame spread is not limited to surfaces which are vertical. It is recognized that an enhanced form of

upward, wind-aided flame spread can also occur on surfaces at an angle greater than 20° from the horizontal

without any external ventilation. This type of flame spread can occur in both planar sloping surfaces and stepped

surfaces such as stairs. Flame spread in these situations can become very rapid and can cause serious problems

in escape ways such as staircases. When assessing stepped or sloping surface materials, it may be more

appropriate to use a vertical flame spread test rather than a test in which the specimen is horizontal.

1.3 This part of ISO 5658 is applicable to the measurement and description of the properties of materials,

products, composites or assemblies in response to radiative heat in the presence of non-impinging pilot flames

under controlled laboratory conditions. The heat source may be considered to represent a single burning item such

as a wastepaper bin or an upholstered chair within an enclosure, and this scenario would generally be considered

to apply during the early developing stage of a fire (see ISO/TR 11696-1 and ISO/TR 11696-2). This part of

ISO 5658 should not be used alone to describe or appraise the fire hazard or fire risk of materials, products,

composites or assemblies under actual fire conditions.

Вы можете ознакомиться с данным стандартом в нашей онлайн-библиотеке (OBP)

Данный стандарт разработан для достижения следующих Цель устойчивого развития

Ознакомьтесь с FAQ

Работа с клиентами

+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)