Committee Draft
ISO/CD 12301
Plain bearings — Quality control techniques and inspection of geometrical and material quality characteristics
Reference number
ISO/CD 12301
Edition 3
© ISO 2024
Committee Draft
Under development
A draft is being reviewed by the committee.
Will replace ISO 12301:2007

Abstract

ISO 12301:2007 specifies quality control techniques and inspection of the geometrical and material quality characteristics of the following types of plain bearings: thin-walled half-bearings with or without flange, as specified in ISO 3548; metallic thick-walled half-bearings (with and without flange) that are manufactured as halves but that are necessarily interchangeable and have the ratio s3 : Do > 0,11; wrapped bushes, as specified in ISO 3547; unsplit metallic bushes (with and without flange) made from solid and multilayer materials and with outside diameters up to 230 mm; solid polymer bushes (with and without flange) with inside diameters up to 200 mm; ring-type thrust washers and pressed bimetallic half-thrust washers, as specified in ISO 6525 and ISO 6526, respectively; and bushes made from sintered material, as specified in ISO 2795.

General information

  • Status
     : Under development
    Stage
    : Committee draft (CD) registered [30.00]
  • Edition
     : 3
  • Technical Committee :
    ISO/TC 123/SC 5
  • RSS updates

Life cycle

Got a question?

Check out our Help and Support

  2. Store
  3. Standards catalogue
  4. TC
  5. ISO/TC 123/SC 5
  6. ISO/CD 12301