Abstract
Applies to products produced in thicknesses of 1,6 mm and over and widths of 600 mm and over, in coils and cut lengths. Hot-rolled sheet less than 600 mm wide may be slit from wide sheet and will be considered as sheet. Specifies conditions of manufacture (steelmaking, chemical composition, chemical analysis, weldability, application, mechanical properties, surface condition), dimensional tolerances, sampling, mechanical property test (tensile test, impact test), retests, resubmission, workmanship, inspection and acceptance, coil size, information to be supplied by the purchaser. Annex A gives information on fabricability.
General information
-
Status: WithdrawnPublication date: 1993-10Stage: Withdrawal of International Standard [95.99]
-
Edition: 2Number of pages: 10
-
Technical Committee :ISO/TC 17/SC 12ICS :77.140.50
- RSS updates
Life cycle
-
Previously
WithdrawnISO 5951:1980
-
Now
-
Revised by
WithdrawnISO 5951:2001
Got a question?
Check out our FAQs
Customer care
+41 22 749 08 88
Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)