Reference number
ISO 15590-3:2004
ISO 15590-3:2004
Petroleum and natural gas industries — Induction bends, fittings and flanges for pipeline transportation systems — Part 3: Flanges
Edition 1
2004-11
Withdrawn
ISO 15590-3:2004
33105
Withdrawn (Edition 1, 2004)

Abstract

ISO 15590-3:2004 applies to weldneck and blind flanges (full face, raised face, and RTJ groove) as well as anchor, swivel-ring flanges and orifice flanges.

ISO 15590-3:2004 specifies the technical requirements for carbon steel and low-alloy steel forged flanges for use in pipeline transportation systems for the petroleum and natural gas industries as defined in ISO 13623.

ISO 15590-3:2004 designates those categories of flanges that meet the industry's need to match ISO 3183 pipe. These flanges are for normal and low-temperature service and include supplementary requirements where required for sour service.

Materials for, or the attachment of, factory-welded extensions, bolting materials, gaskets, slip-on flanges or flanged fittings are not covered by ISO 15590-3:2004.

ISO 15590-3:2004 is not applicable to integrally cast or forged flanges for valves, pumps or other equipment.

ISO 15590-3:2004 does not cover the selection of the flange category or pressure class. Sizes and pressure classes listed in ISO 7005-1 and applicable to ISO 15590-3:2004 are as follows:

  • DN 10 (NPS 1/2) to DN 1500 (NPS 60);
  • PN 20 (class 150), PN 50 (class 300), PN 100 (class 600), PN 150 (class 900), PN 250 (class 1500), PN 420 (class 2500).

General information

  •  : Withdrawn
     : 2004-11
    : Withdrawal of International Standard [95.99]
  •  : 1
     : 17
  • ISO/TC 67/SC 2
    75.200 
  • RSS updates

Life cycle

Got a question?

Check out our Help and Support